
Your cooperative offers you ammonium sulphate for the second nitrogen application, and you hesitate: at what rate, on which fields, and with what effect on a soil that is already acid? Ammonium sulphate, a nitrogen and sulfur fertilizer, is easier to understand when you see it as a sulfur carrier with nitrogen attached.
Ammonium sulphate fertilizer 21-0-0 remains the benchmark for supplying sulfur in directly available sulphate form. The Ooreka fertilizer sheet gives its standard composition, 21% ammoniacal nitrogen and 60% sulfur trioxide, for a product more than 98% pure. This sulfur comes from a single raw material, sulfuric acid, itself produced from the solid sulfur described on our page on sulfur trading.
Ammonium sulphate fertilizer: formula and contents, 21-0-0 + 60 SO3
The chemical formula is (NH4)2SO4. The salt forms through the reaction between ammonia and sulfuric acid, explains the Spanish distributor Delso, and it combines an ammonium cation NH4+ with a sulphate anion SO4²⁻. One hundred kilos of product supply 21 kg of nitrogen and 60 kg of SO3, i.e. 24 kg of elemental sulfur, the opposite ratio to sulfur-containing ammonium nitrates, which are much richer in nitrogen. See our article on nitrogen-sulfur fertilizer.
The sheet from the Walloon Chamber of Agriculture published by Protect’eau classifies ammonium sulphate among fertilizers with a steady release of nitrogen and describes it as highly acidifying. The nitrogen, entirely ammoniacal, is held by clay and organic matter before being nitrified, which protects it from leaching according to the same Ooreka sheet.
Ammonium sulphate fertilizer: two production routes, two qualities
The product comes either from direct synthesis, ammonia plus sulfuric acid, which gives a granule sized for spreading, or from by-product recovery in caprolactam plants, coking plants or flue gas desulphurisation. According to Global Market Insights, this by-product route accounts for 68.4% of world supply, and agriculture absorbs 75.4% of consumption, mainly for rice, wheat and maize.
Ammonium sulphate fertilizer: dosing is calculated in units of SO3
Ammonium sulphate fertilizer is dosed from the crop’s sulfur requirement, and the nitrogen that comes with it is then deducted from the nitrogen fertilization plan.
On cereals
The Arvalisgrid, based on more than 350 trials, recommends 20 to 50 kg of SO3 per hectare on high-risk soils that do not receive regular organic matter, with an application between mid-tillering and the 1 cm ear stage. The institute puts yield losses at up to 20 q/ha in the most deficient situations.
With ammonium sulphate fertilizer, 50 units of SO3 correspond to 83 kg of product, which also supply 17 to 18 kg of nitrogen. For compound fertilizers, Arvalis recommends an N/SO3 ratio of between 2 and 3, hence the practice of applying straight ammonium sulphate in addition to a first application of nitrogen alone. Our article on sulfur for wheat details this grid.
On oilseed rape and demanding crops
Oilseed rape needs about 75 kg of SO3 per hectare in sulphate form at the start of stem extension, as we explain in the article on sulfur for oilseed rape. In straight ammonium sulphate, this represents 125 kg of product and 26 kg of nitrogen. Delso also lists citrus, almond trees, rice and maize among the crops regularly fertilized with ammonium sulphate.
| Sulfur target | Ammonium sulphate (21-0-0 + 60 SO3) | Nitrogen supplied at the same time |
|---|---|---|
| 30 kg SO3/ha (wheat, moderate-risk soil, Arvalis) | 50 kg/ha | about 10 kg N/ha |
| 50 kg SO3/ha (wheat, high-risk soil, Arvalis) | 83 kg/ha | about 17 kg N/ha |
| 75 kg SO3/ha (oilseed rape, Terres Inovia benchmark, see sulfur for oilseed rape) | 125 kg/ha | about 26 kg N/ha |
Ammonium sulphate fertilizer and pH: an acidifying product to factor into liming
The acidifying effect of ammonium sulphate comes from the nitrification of ammonium, which releases H+ ions, and from the sulphate anion, which carries calcium down the profile. A study by the IRD published in the journal Fruits in 1959, on banana plantations, measured a pH drop from 6.8 to 6.4 after incorporating the product into an initially neutral soil, with average leaching of 0.4 milliequivalents of lime per 100 g of soil. Delso draws the practical conclusion: ammonium sulphate is best suited to calcareous and alkaline soils, where acidification becomes an advantage for the availability of phosphorus and trace elements.
On an acid silt in Brittany or a sandy soil in the Landes, the product can still be used, but the amount of lime to plan in the rotation increases. On calcareous soil, however, the ammoniacal form limits the risk of volatilisation compared with urea and nitrogen solution; the sheet from Protect’eau highlights their sensitivity to gaseous losses.
Liquid ammonium sulphate fertilizer: fertigation, foliar feeding and corrective applications
The salt dissolves easily in water, which makes fertigation possible in fruit growing and market gardening, where the crystalline powder is used directly in the tank. Delso also sells a ready-to-use liquid formulation containing 8.4% nitrogen and 24% SO3, and points out that the solubility of ammonium sulphate remains lower than that of ammonium nitrate, hence a 40% dilution in concentrated solutions. In hydroponics, the same source caps its share at 15 or 20% of total nitrogen, so as not to tip the nutrient solution towards ammonium.
Liquid ammonium sulphate fertilizer is also used to correct a deficiency detected in spring. The website Fertilisation-edu reports CETIOM’s recommendation of 60 kg of SO3 per hectare as ammonium sulphate diluted in 500 litres of water on deficient oilseed rape. Its use as a spray adjuvant and handling precautions are covered in our article on ammonium sulphate and its safety data sheet.
A by-product market with very different prices by region
According to ChemAnalyst, the tonne was trading in June 2026 at around 238 dollars in China, 258 dollars in South Korea, 350 dollars in India, close to 395 dollars as a quarterly average in Germany and 486 dollars in the United States. The same source attributes the Asian decline to an abundant supply of by-product from caprolactam and coking plants. In Europe, Terre-net quoted ammonium nitrate 27 at 440.50 euros a tonne ex works in early September 2026.
The sulfur contained in the product also weighs on the price. The 2026 global sulfur crisis has made sulfuric acid more expensive, and therefore the cost of direct synthesis, and pushed manufacturers in Europe and North Africa to secure sources of solid sulfur outside the Gulf. For an Algerian distributor buying 21% ammonium sulphate from Profert, the delivered price therefore depends on sulfur availability at the acid producer.
What E-Station does
E-Station supplies the solid sulfur used to make sulfuric acid, and therefore ammonium sulphate fertilizer and other sulfur fertilizers. We supply acid producers, fertilizer manufacturers and industrial companies with granules, pastilles or crushed lumps, in bulk or in big bags, with a certificate of analysis for each lot and origins outside the Gulf. Our sulfur trading hub presents the available grades; buyers in North Africa will find delivery conditions on sulfur in Morocco and sulfur delivery to Algeria, and European industrial buyers on sulfur in France. Shipping logistics are organised up to unloading, on FOB, CFR, CIF or DAP terms.
Frequently asked questions
Ammonium sulphate fertilizer: what formula and what contents?
The formula is (NH4)2SO4. The fertilizer contains 21% ammoniacal nitrogen and 60% SO3, i.e. 24% elemental sulfur. One hundred kilos of product therefore supply 21 kg of nitrogen and 60 kg of SO3.
What rate of ammonium sulphate on wheat or oilseed rape?
The rate is calculated from the sulfur requirement. For 20 to 50 kg of SO3 per hectare on cereals, according to the Arvalis grid, you need 33 to 83 kg of ammonium sulphate. For 75 kg of SO3 on oilseed rape, the rate rises to 125 kg, which also supplies 26 kg of nitrogen to deduct from the fertilization plan.
Why does ammonium sulphate lower soil pH?
Nitrification of ammonium releases H+ ions and the sulphate carries calcium down the profile. Older IRD measurements show a pH drop from 6.8 to 6.4 after incorporation. The product is therefore best suited to calcareous and alkaline soils, and liming needs to be reviewed on acid soils.
When should liquid ammonium sulphate be used?
The liquid form is used in fertigation, in hydroponics, where it should not exceed 15 to 20% of total nitrogen, and to correct deficiencies. CETIOM, for example, cites 60 kg of SO3 per hectare as ammonium sulphate diluted in 500 litres of water on deficient oilseed rape.
How much does ammonium sulphate cost per tonne?
The price varies greatly by region. In June 2026, ChemAnalyst recorded about 238 dollars a tonne in China, 395 dollars in Germany and 486 dollars in the United States. The cost of sulfur and sulfuric acid weighs on the direct synthesis route.
You produce sulfuric acid or ammonium sulphate fertilizer and are looking for a supply of certified solid sulfur, from outside the Gulf, delivered to the port of your choice. Request a quotation stating the expected purity and delivery rate gets you a firm price rather than an indicative range.