Skip to main content

Receiving and discharging bitumen on site: checks and safety

Réception et dépotage du bitume sur chantier
ENERGY TRADING · PRACTICAL GUIDES

Receiving and unloading bitumen

Checks, delivery temperature and safety during unloading.

Request a quotation →

Receipt of bitumen on site is the moment when the actual conformity of the delivered binder is decided. Poorly controlled unloading, a neglected check or badly monitored temperature can compromise a batch that was compliant when it left.

Here are the steps that secure receipt, from the document check to unloading into the tank.

Check before unloading

Receipt begins with a cross-check between the delivery note, the certificate of analysis and the grade ordered. Any discrepancy in grade or quantity must be resolved before unloading, never afterwards.

The certificate of analysis links the delivered batch to the characteristics of the EN 12591 standard and is the first document to check.

Check the delivery temperature

Bitumen is unloaded hot, within a precise temperature range. Too cold, it does not flow properly; too hot, it ages faster. The temperature reading on arrival is part of the receiving check.

The mechanisms of thermal degradation are described in our guide to ageing of bituminous binder.

Safe unloading

Unloading involves a hot product under pressure. A few rules limit risks and losses:

  • Protected personnel and a clear area during the operation.
  • Couplings checked and leak-tight before transfer.
  • Receiving tank at controlled temperature and volume.
  • Sample taken and kept in case of dispute.

Maintaining quality in the tank

Once unloaded, the binder must be kept at temperature until use. Prolonged or localised heating degrades bitumen. Good practice for storing and heating bitumen applies directly to the site tank.

Trace and keep the evidence

Keeping the delivery note, certificate of analysis, temperature readings and sample protects the buyer. If defects appear later, this traceability makes it possible to tell a product defect from an application problem.

Checking the quantity delivered

Beyond quality, quantity is part of receipt. Checking the weight or volume unloaded against the delivery note protects the buyer from an invoicing discrepancy. Tankers have gauging marks, and weighing on arrival removes any doubt about the tonnage actually delivered.

Coordinating receipt and application

Receipt is planned together with the application schedule. A binder unloaded too early and held in the tank for a long time degrades, whereas a delivery synchronised with application preserves its characteristics.

  • Delivery synchronised with the start of the application crew.
  • Tank volume matched to the site’s rate of consumption.
  • Controlled heating with no prolonged localised overheating.

This coordination extends the requirements for bitumen storage and heating : each delivery must fit the pace of the site so that the binder does not sit in the tank for long.

Frequently asked questions

What should be done if there is doubt about the grade delivered?

Suspend unloading, compare the delivery note and the certificate of analysis, keep a sample and resolve the discrepancy with the supplier before any transfer.

Should the temperature be measured on arrival?

Yes. The delivery temperature reading governs both flow and the preservation of the binder’s characteristics.

Why keep a sample?

A sample taken on receipt makes it possible to settle objectively any later dispute over the conformity of the batch.

Need a quotation? E-Station draws up a priced offer, grade by grade, with a certificate of analysis and specified delivery terms. Request a quotation.

No comments yet!

Votre adresse email ne sera pas publiée.