
Mid-May in the Landes: your five-leaf maize is pale green, the newest leaves are striped with yellow, and the neighbour on silt has no problem. The soil is still cold and the nitrogen went on at sowing. This picture points to sulfur, and sulfur for maize is decided plot by plot.
Maize is seen as a crop with low sulfur demand, and yet the fact sheet from Yara France puts its total uptake at 65 kg of SO3 per hectare, alongside 240 kg of nitrogen and 270 kg of potash. This sulfur comes from soil mineralisation, from manures and slurries and, more and more often, from a fertilizer whose raw material is the solid sulfur presented on our page on sulfur trading. This article argues a simple idea: sulfur for maize should be treated as a localised risk, with a control strip, and corrected with a modest rate applied at the right time.
Sulfur for maize: what does the crop really need?
Maize takes up most of its nutrients before tasselling. Yara France specifies that more than 50% of the nitrogen, phosphorus and magnesium and more than 80% of the potassium are taken up before this stage, and sulfur follows the same calendar as nitrogen, whose uptake it governs. Of the 65 kg of SO3 taken up, most returns to the soil with the stalks, and removal in the grain remains modest. The soil of a plot with adequate organic matter therefore supplies most of it, provided it mineralises when the plant needs it.
Sulfur for maize: why deficiency occurs in a cold spring
The problem with maize lies in its calendar. The plant starts in April-May, when the soil is still cool and mineralisation of organic sulfur is slow, while the sulfate built up in autumn has been washed away by winter rain. Yara adds two aggravating factors: heavy rainfall and no-till continuous maize, which deplete the surface layer of available sulfur.
Bayer Crop Science Canada observes that deficiencies often disappear by themselves when the soil warms up and dries out, which explains why growers often hesitate to act. The same document nevertheless puts a figure on what is at stake: at 21 days after emergence, each day of sulfur deficiency can cost 1 to 2 bushels per acre.
Sulfur deficiency in maize: recognising the symptoms at 4-5 leaves
The Arvalis crop-disorder sheet places the onset of symptoms from the 4-5 leaf stage. The plant takes on a yellowish look, especially on the most recent leaves, with yellow discolouration between the veins that starts at the base of the leaf and can spread to older leaves, while the mature foliage sometimes stays green.
Yara describes an upright plant with delayed growth, whose young leaves look uniformly pale from a distance and, close up, show yellow-green discolouration edged with fine brown lines. Arvalis rates the damage at 3 out of 5 for a frequency of 1 out of 5, linked to sandy soils: the problem is rare, and costly where it strikes.
Telling sulfur apart from nitrogen, magnesium and manganese
The key, as on wheat or oilseed rape, lies in the age of the affected leaves. Bayer Canada points out that sulfur moves poorly within the plant, so the young leaves turn yellow and striped first, whereas nitrogen deficiency first yellows the lower leaves along the midrib.
Arvalis rules out two other confusions: magnesium deficiency gives interveinal discolouration with reddening and white spots on older leaves, and manganese deficiency comes with a drooping habit. When doubt persists beyond the V5 stage, Bayer Canada advises tissue analysis, which Arvalis charges at between 15 and 20 euros excluding tax per sample.
Sulfur for maize: the plots to watch
Both institutes point to the same soils: sandy, shallow and low in organic matter, where sulfate is leached and mineralisation is weak. Yara adds acidic soils, poorly aerated or waterlogged soils and regions far from industrial emissions. In the Landes, Yara reports yield gains after sulfur application on sands low in organic matter. On the deep silts of the Paris Basin or the clays of the South-West, the risk remains low and application is rarely profitable.
Sulfur application on maize: how much and in what form?
The sulfur rate for maize remains modest compared with that for oilseed rape. Arvalis uses 25 to 50 kg of SO3 per hectare, preventively before sowing in at-risk areas or curatively as soon as symptoms appear, and Yara considers an application of 30 to 50 kg of SO3 per hectare sufficient where there is a risk of deficiency. This range covers half to three quarters of total uptake, which is enough because the soil takes over as soon as it warms up.
Sulfur for maize at sowing, with the nitrogen
The most effective time is the main nitrogen application, at sowing or at the 4-6 leaf stage, with a directly available sulfate form. Arvalis lists ammonium sulfate, magnesium sulfate, calcium sulfate, potassium sulfate and micronised sulfur. Ammonium sulfate, which we cover in the article ammonium sulfate fertilizer, supplies 50 kg of SO3 with 83 kg of product and 17 kg of nitrogen, which fits easily into a maize fertilization plan.
Sulfur-containing ammonium nitrates such as 24+18 play the same role on at-risk plots, and elemental sulfur, which is slower, is kept for maintaining the soil stock on the preceding crop, as we explain in the article on elemental sulfur in agriculture.
Foliar catch-up between 4 and 8 leaves
Once the yellow stripes are there, the foliar route is the fastest. Yara recommends for its thiosulfate Thiotrac 300 a rate of 5 litres per hectare in 200 litres of water at the 4-8 leaf stage, repeatable every 10 to 15 days if necessary. Spraying relieves the plant while the soil warms up; a soil application is still needed on plots where the deficiency returns every year. We detail the technique in the article on foliar sulfur application.
What the North American trials say
Canada and the Midwest have seen sulfur deficiency in maize increase as atmospheric deposition has fallen. Ontario Grain Farmer reports that wet sulfur deposition in Ontario fell from 8 to 13 pounds of sulfur per acre per year in 1990 to 2 to 4.5 pounds in 2014. In the University of Guelph trials run in 2018 and 2019 at five maize sites, two responded significantly to sulfur and only one produced a profit, with a gain of 16.5 bushels per acre, whereas 21 OMAFRA trials on starter fertilizer in 2012-2013 had measured no benefit.
The lesson matches that of Arvalis, and it holds for sulfur on maize on both sides of the Atlantic: the response exists, it is strong where it exists, and it is checked with a sulfur-free control strip in the plot. Cereal growers will find the same decision-grid logic in our article on sulfur for wheat.
Where the sulfur in your starter fertilizer comes from
The ammonium sulfate, sulfur-containing ammonium nitrate or thiosulfate applied to maize contain sulfur derived from sulfuric acid, and therefore from solid sulfur co-produced by refining and gas processing. The 2026 global sulfur crisis showed that this link can fail: when the Gulf stops exporting, fertilizer manufacturers in France and Canada have to find other origins, and the price of the 50 units of SO3 for maize depends directly on it.
What E-Station does
E-Station supplies solid sulfur to sulfuric acid producers, fertilizer manufacturers and the distributors who serve the maize-growing regions, where sulfur for maize is decided in a few weeks of spring. The sulfur is offered as granules, pastilles or crushed lump, in bulk or in big bags, with a certificate of analysis per batch and origins outside the Gulf. Our sulfur trading hub presents the grades available; the page on sulfur in France describes deliveries to the Atlantic ports serving the South-West, and the pages on sulfur in Canada and sulfur delivery to Canada cover the sea logistics through to unloading, on FOB, CFR, CIF or DAP terms.
Frequently asked questions
What is the sulfur requirement of maize?
Yara France puts total uptake by maize at 65 kg of SO3 per hectare, most of it absorbed before tasselling. The greater part returns to the soil with the stalks, and the soil of a plot with good organic matter covers this need as soon as it warms up.
How do you recognise sulfur deficiency in maize?
From the 4-5 leaf stage, the young leaves turn pale and become striped with yellow between the veins, while the lower leaves often stay green. Nitrogen deficiency, by contrast, yellows the lower leaves. A tissue analysis removes the doubt beyond the V5 stage.
What rate of sulfur should be applied to maize?
Arvalis uses 25 to 50 kg of SO3 per hectare, preventively before sowing on at-risk sandy soils or curatively at the first symptoms. Yara considers an application of 30 to 50 kg of SO3 per hectare in sulfate form sufficient, with the main nitrogen application.
Which maize plots are at risk of sulfur deficiency?
Sandy, shallow, acidic or low-organic-matter soils, especially after a wet winter and during a cold spring. No-till continuous maize and plots receiving no manure or slurry are also more exposed, according to Arvalis and Yara.
Can sulfur deficiency in maize be corrected with a foliar spray?
Yes, between 4 and 8 leaves. Yara recommends 5 litres per hectare of thiosulfate Thiotrac 300 in 200 litres of water, repeatable every 10 to 15 days. Foliar application relieves the plant while the soil warms up, and a soil application remains necessary on plots where the deficiency returns every year.
You manufacture or distribute the sulfur fertilizers used on maize and are looking for a certified supply of solid sulfur, from outside the Gulf, delivered to the port of your choice. Request a quotation giving the tonnage and the delivery window you want, to secure the sulfur before the spring peak.